VdS Approval n. S 322008
|
SicurEX.INERT™
|
SicurEX GREEN POLICIES
We focus only on green technologies. Our products or systems are made using selective and environmentally friendly materials, which can be recycled even at the end of the product's life cycle.
Zero Ozone Depletion
SicurEX is committed to using gases with a zero effect on the ozone layer.
ZERO Global Warming Potential
SicurEX is committed to using gases with zero global warming potential.
SicurEX.INERT ™
|
WHAT is the INERT gas?
Inert gas is a colorless, odorless, electrically nonconductive gas with a density approximately the same as air. Inert gas is stored as pressurized within the cylinder assembly.
When discharged into a protected space, it is clear and does not obscure vision.
It leaves no residue.
SMART SIMPLE EASER
SicurEX Inert systems is designed for simplify the installation.
FULL SYSTEM PACKAGE WITH 200 OR 300 BAR CYLINDERS
Pressure monitoring gauge and low-pressure switch as standard. Up to 79 cylinders may be operated from a single solenoid actuator mounted on the master cylinder Cylinders can be banked in single, double rows for a compact installation footprint Single or multiple zone protection is available from a single cylinder bank Diverter valves are driven from the discharge manifold avoiding additional pilot cylinders and valves Nozzles may be installed in the middle of the room or side wall mounted for ease of installation Flow calculation software from VdS for reliable system design
PRESSURE REGULATOR CONSTANT FLOW TECHNOLOGY
Constant-Flow-Technology is intended for use as a dynamic constant pressure controller device installed to the Manifold. This controlled pressure will be a maximum of 60 bar.
The dynamic constant pressure controller eliminates the peak pressure and regulates the flow at a nominal pressure of 60 bar in the 300 bar or 200 bar systems version, whilst maintaining the ability to achieve 95% of system design concentration within 60 or 120 seconds.
The benefits of A PRESSURE CONTROLLED DISCHARGE
Reduced pipe work costs Reduced over pressure venting area Reduced discharge noise Perfect for extending systems Smaller nozzles
CLASS OF FIRE
Safe and suitable for EN Class A, B, Electrical Fires and NFPA2001-22 Class A, B. and C
TRAINING & SUPPORT
Customer training is a training offered to our partners so they can install and use SicurEX systems in full capacity. Our customer support team helps our partners to solve problems.
All the parts used in a single or bank of cylinders are listed and described in this catalogue.
SicurEX manual of installation is available to describe steps by steps to install these parts correctly.
CENTRALIZED SYSTEMS |
MULTIZONE SYSTEMS |
MODULAR KITS – REGULATED SYSTEMS
|